Borg Ship Assembly Brackets and Stand

This is an assembly bracket and display stand for the original Borg Cube design. I found the ship parts difficult to assemble so I designed and printed these brackets. Print two of them for one cube. Also is a display stand to show off your finished project.

So, the original design was too large for my printer, so I reduced it by 50%. These brackets fit a 50% reduction in size. If you print the cube at its original size, scale these brackets to 200% when you print them. Same with the stand. Actually, the stand you may have to play around with the scale to get it to whatever size you like. Just eyeball it in your printer program.

The original design has the parts numbered. Take a close look at the included files and match up each numbered part with how they are laid out in the master file. I put a piece of tape on each one and numbered them accordingly. Then, I drew arrows so I could remember their orientation when I glued them together. Even doing this, I ended up gri