Thingiverse
Bosch Hob Igniter Button
von garethl
1
Downloads
2
Likes
0
Makes
This is a small button that goes on the igniter stalk at the bottom right of the hob. The button slides over the stalk.
Printed at .2 mm, 40% infill. I had to drill out the center hole slightly for it to fit snugly on the stove top.
Printed at .2 mm, 40% infill. I had to drill out the center hole slightly for it to fit snugly on the stove top.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!