Bosch PCM8 saw zero clearance insert

This is a blind insert replacement for the PCM-8 miter saw, so you can create a zero clearance slot. This will NOT fit the PCM 8S sliding saw , only the basic PCM-8


WARNING: Intented for use at a fixed angle (vertical in pictures). Iif you change the vertical angle of the disc, it will be a good idea to print a different cover, as the new angle will carve a second slot and this might compromise integrity. You can also just use the stock cover for those cuts.

+ V1 is the one shown in pictures had some measurement errors in the holding tabs that required processing. Z height is tiny bit down, but can be adjusted with some padding on the feed inside.
+ V2 is the one uploaded here untested, but should work straight from the printer. Z height has also been tuned .1 mm, but you might need to tune it depending on the material shrinkage.

----------------

- Printer brand:
Bambulabs

- Printer:
Bambu P1S

- Birm / Rafts:
No

-Supports:
Probably ot necessary*.

* the screw hole and the tw