Thingiverse
Bose Cube Speaker Connector
von Iciclelover7882
2
Downloads
3
Likes
0
Makes
The original connector is in white. After a few revisions to adjust the OD of the tabs, it finally engaged without breaking. PLA may be a little brittle.
Designed in Tinkercad.
It was difficult to insert, but if you square it up, put a bar on it, give it a whack with a mallet and it snapped right in.
Designed in Tinkercad.
It was difficult to insert, but if you square it up, put a bar on it, give it a whack with a mallet and it snapped right in.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!