Thingiverse
Bot_6v1
von AstroDesigns
4
Downloads
6
Likes
0
Makes
A variation on the MicroPiNoon 'Bot Thing...
Easier to print
Easier to assemble
Can be used as a two-wheel version or a four-wheel option
Suited for the Raspberry Pi Zero with the PiZ-Moto+ motor driver
Requires six 16mm nylon spacers with M3 stud on one end and M3 threaded hole at the other end. Length not critical, anything in the region of 15mm to 20mm is probably ok.
Easier to print
Easier to assemble
Can be used as a two-wheel version or a four-wheel option
Suited for the Raspberry Pi Zero with the PiZ-Moto+ motor driver
Requires six 16mm nylon spacers with M3 stud on one end and M3 threaded hole at the other end. Length not critical, anything in the region of 15mm to 20mm is probably ok.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!