Thingiverse
BOTT Knipex Hook
door michigebel
24
Downloads
33
Likes
0
Makes
This is a hook designed to hold Knipex Pliers on a Bott tool Pegboard.
There are two Versions. The shorter one is for standard-sized Knipex Pliers. The longer one should fit the VDE version with the broader handle.
Print with supports on the side.
This holder should fit pretty snugly onto the Board. If it is too loose, heat the back hooks with a hairdryer and adjust them to your desired fit. With my prints, there was no need for that though.
There are two Versions. The shorter one is for standard-sized Knipex Pliers. The longer one should fit the VDE version with the broader handle.
Print with supports on the side.
This holder should fit pretty snugly onto the Board. If it is too loose, heat the back hooks with a hairdryer and adjust them to your desired fit. With my prints, there was no need for that though.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!