Bottle Cap Camera Screw

This is a small thing to screw your selfie stick on a bottle ...
nice to take a picture of the entire family, after a nice evening.

This can replace a tripod , but takes no room in a bag and can remain screwed to your selfie stick ...
Can ' t be cheaper ...


Note: it could also be usefull if you use my selfie stick stabilizer (http://www.thingiverse.com/thing:2017905)


Thanks to mike_mattala for his great openscad file which i used to gneerate the 1/4 inch screw.

Be sure to print the screw with at least 70% infill.
Do not let it cooll down : immediately screw it afer the ens of the print, so that it takes the correct form.


2 small screws are needed to maitain he screw on the bottle cap.


Disclaimer : be carefull : test the stability before you leave your phone attached to a bottle, and ensure no one is playing with a ball around ! . I am not respopnsible for any usage right or wrong that you plan to have with that little thing.