Slicer Discord
Bottle Drain Funnel Set – Modelo 3D imprimible de Thingiverse Thingiverse

Bottle Drain Funnel Set

15 Descargas
9 Likes
0 Makes
Ver Modelo
Very few (if any) pump bottles give you all of the contents that the bottle contains - There is almost always some left at the bottom. The "straw" is too short or doesn't reach the corner at the bottom. Anyway, this set of funnels allows you to stack and gravity-drain the old bottle's contents into the new bottle without (hopefully) spilling a drop. The funnels are named according to the inside and outside diameters (in millimeters) of the bottles, and you use the one closest to your bottle's dimensions. Just screw off the pump on both, put the funnel inside the opening of the nearly-full bottle, and put the nearly-empty bottle upside down into the top of the funnel. Then let gravity do its thing. Thicker soaps or creams will take longer of course, but nearly all of the contents will flow into the lower bottle. Make sure before you start that there is enough room in the new bottle for the top-up, just saying ...
There are three funnels at the moment, and I will add more, so please sug
Fuente
Thingiverse
Lo que necesitas para imprimir: Intermedio Baja confianza
Pieza única Tornillería requerida
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 1/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
Postprocesado
Tornillería
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

4 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección