Thingiverse
Bottle Lab Berlin - Fitting Check
von BottleLabBerlin
7
Downloads
5
Likes
0
Makes
Ready or your own BottleLab Table/Bench/Shelf?
Start here!
Make a short testprint, to make sure, that you have the right diameter for your bottles.
If you know the right diameter continue here: [[comming soon]]
Maybe you can skip this step, if you can find your bottle in the list below.
0.5l Club Mate (in GER) - 30mm
0.5l Fritz-Limo (in GER) - 30mm
0.75l Viva Con Aqua (in GER) - 30mm
0.33l Lemonaid (in GER) - 30mm
almost every "Mehrwegflasche" in Germany - 30mm
Start here!
Make a short testprint, to make sure, that you have the right diameter for your bottles.
If you know the right diameter continue here: [[comming soon]]
Maybe you can skip this step, if you can find your bottle in the list below.
0.5l Club Mate (in GER) - 30mm
0.5l Fritz-Limo (in GER) - 30mm
0.75l Viva Con Aqua (in GER) - 30mm
0.33l Lemonaid (in GER) - 30mm
almost every "Mehrwegflasche" in Germany - 30mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!