Thingiverse
Bottle Lamp
von maxpower601
15
Downloads
13
Likes
0
Makes
The bottle-holder has to be printed upside down using dense support. If possible use Nylon because PLA tends to get brittle when exposed to UV-Light.
The Spacer is not mandatory but can be used to fit the bulb level.
The design
The Spacer is not mandatory but can be used to fit the bulb level.
The design
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!