Thingiverse
Bottle Mold
por Quinian
62
Descargas
41
Likes
0
Makes
Slightly redid the bottle and made a mold out of it
Print at 100% infill, make sure to use a mold release of some kind, and a low temp glue gun. You can clamp them together however you like, I used a tiny vice because it was handy but rubber bands should work fine. 1 full squirt from the glue gun into each hole should do it.
The .blend file is labeled WIP but that's just so I can find it easy, it works well printed as is.
Print at 100% infill, make sure to use a mold release of some kind, and a low temp glue gun. You can clamp them together however you like, I used a tiny vice because it was handy but rubber bands should work fine. 1 full squirt from the glue gun into each hole should do it.
The .blend file is labeled WIP but that's just so I can find it easy, it works well printed as is.
Quinian también publica en
3 modelos adicionales en 1 plataformas más
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!