Bottle Top Rattler

sorry this is missing stuff.
It's my first make in tinkercad and my first upload to thingiverse

The smaller one is the stl that says "rounded edges"

I made this to use up some bottle caps I had.
it will drive mom nuts, but could also be used at sporting events.
the smaller one was made on a flash forge.
the larger one in red was made on my Anet 4.
I ran coated wire throught the holes and super glued each hole.
I ran about 15% fill on the white pla one
and I ran 100% fill on the red one.

15% fill is enough.

I made it in tinkercad and then exported into cura for slicing.

no rafts needed.