Bottle Washer Fountain Conversion

This is my first REMIX so be gentle! I printed this today as a possible bottle washer. It worked great as the fountain it was meant to be. It just didn't have enough power to reach very far into a bottle. All I did was "Tim Allen" it up a bit. I narrowed the end of the spout and "WOW" power washer extraordinaire! It really blasts the tallest bottles beautifully. Make sure you have the bottle over the spout before blocking the through hole on the bottom or your whole kitchen will be wet! If you need to clean out huge PET bottles to recycle into filament or other products, this will do the trick. The only other thing I'm going to do is add a longer spigot because large bottles fill quickly and drown out the short spigot's efficiency. Using short bursts of water, then allowing some water to drain out in between bursts works the best.