Thingiverse
BottleFish
by JNS
57
Downloads
63
Likes
0
Makes
This is a bottlefish made of a 0.5 litre softdrink bottle. It is a toy to play in the water. We believe that it is a good way the introduce the concept of hackability.
The bottom fins need a piece of threaded bar inserted to provide stability in the water.
There is a spring inlet modeled in the rear fin/fin folder to keep the fin straight.
Top/Left/Right/Bottom Fins need to be glued to the bottle.
The rear fin holder should be pushed on the bottle cap.
The parts from the bathtub bottle submarine,bottle fish and spaceship lamp are all based on the same bottle and are therefore exchangeable. Therefore you can recombine all 3 designs as you like.
Important: Please use epoxy glue to have a robust model that lasts longer than just two hours at the lake.
The bottom fins need a piece of threaded bar inserted to provide stability in the water.
There is a spring inlet modeled in the rear fin/fin folder to keep the fin straight.
Top/Left/Right/Bottom Fins need to be glued to the bottle.
The rear fin holder should be pushed on the bottle cap.
The parts from the bathtub bottle submarine,bottle fish and spaceship lamp are all based on the same bottle and are therefore exchangeable. Therefore you can recombine all 3 designs as you like.
Important: Please use epoxy glue to have a robust model that lasts longer than just two hours at the lake.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!