Thingiverse
Bottom Mount Micro-Switch Holder
by smappdooda
9
Downloads
6
Likes
0
Makes
I needed a holder for a small micro-switch to be mounted in a certain way for an escape room prop I was building. I figure someone else might need it eventually too. Fits a 20mm x 4mm micro-switch.
Due to irregularities in molding and printing, some parts will fit snug and others will fit loose. You can glue them in or drill some holes to bolt/screw them in place.
Due to irregularities in molding and printing, some parts will fit snug and others will fit loose. You can glue them in or drill some holes to bolt/screw them in place.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
