Thingiverse
BOTW Hyrule Map Case Double-sided
von West3DP
24
Downloads
30
Likes
0
Makes
A clear acrylic double-sided case for my map of Hyrule from the Explorer's Edition of Legend of Zelda Breathe of the Wild. The map has all of Hyrule on one side and a zoomed in look at the Great Plateau on the other, so I wanted something that could display both sides and keep it protected.
I cut the front and back from 3 mm clear acrylic, and designed Triforce holders for the four corners. I printed these in NinjaFlex so that I could squeeze one side through and be able to remove them later if needed.
The holes in the holders are also sized so that they can slip over push pins to hang, or it can lay flat on a table.
I cut the front and back from 3 mm clear acrylic, and designed Triforce holders for the four corners. I printed these in NinjaFlex so that I could squeeze one side through and be able to remove them later if needed.
The holes in the holders are also sized so that they can slip over push pins to hang, or it can lay flat on a table.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!