Thingiverse
bow cannon
by Huib13
88
Downloads
88
Likes
0
Makes
this thing is a small working model of the bow cannon, a weapon of my own design.
ideal for an office warfare or for shooting paper bullets to your annoying sister.
important information: you will need a rubber band and a cocktailstick.
you could use 2 rubber bands if you want.
you also may have to vile down the ring of the bow part a bit, because otherwise it might not fit on to the body of the cannon.
it shoots about 4 meters far with one rubber band.
printing information:
i used a brim because i printed it in ABS.
the temperature i used was : 240c for the Hotend and 60c for the heated Bed.
it took about 4 hours and 20 minutes to print all the parts.
the speed: 50% layer height: 0.2 mm
please give me a like and have fun shooting your sister and colleagues!
ideal for an office warfare or for shooting paper bullets to your annoying sister.
important information: you will need a rubber band and a cocktailstick.
you could use 2 rubber bands if you want.
you also may have to vile down the ring of the bow part a bit, because otherwise it might not fit on to the body of the cannon.
it shoots about 4 meters far with one rubber band.
printing information:
i used a brim because i printed it in ABS.
the temperature i used was : 240c for the Hotend and 60c for the heated Bed.
it took about 4 hours and 20 minutes to print all the parts.
the speed: 50% layer height: 0.2 mm
please give me a like and have fun shooting your sister and colleagues!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!