Bow // Limps Quiver V2

V2 of my simple Bow Quiver. All parts exept "unten.stl" are printed with Filaflex. Unten.stl was printed using ABS, but you can also use PLA. Just print all Filaflex parts with at last 50% infill. You also need 2 parts of a 7mm pipe to fasten the quiver on the bowy a log 6mm screw and a nut for the part unten.stl. The length of the screw depends of the with of your limps. I use a piece of a Goldtip Warrior 600 Arrow. Glue the pipe in "kocher" then use "schutz" to hold the quiver on the correct place. Use some strong Rubber Bands to fasten the quiver on the limbs. I use a piece of a bicycle tube. At last you can use "stopfen" to close the pipe on the outside. I filled the quiver with Foam.

Note: For a german speaking people, the "unten.stl" was wrong named. This is the upper part of the quiver :-)