Bow-TIE Fighter

Inspired by this: https://www.printables.com/model/46756-bow_tie-fighterI present to you my version, made from scratch (which is a big deal, I am NOT well-versed in 3D modeling).There are TWO versions, a solid version and a mesh version. I have not tried printing the mesh version yet, so if you do, please upload a picture and tell me how it went. I spent a LOT of time making those holes line up properly.I would recommend support for the bottom side where the slot is, but you might be able to get away with no supports. I would recommend doing it regardless, because no one would see that area anyway. I printed at 50% infill, but that was likely overkill. Still, it's been rock solid and it's a fairly small piece, so it might be worth the slightly extra filament. If you want dual color like I did, insert 2 filament changes! I did it at layer 6 and 26, printing at 0.2 mm; your experience may differ, defer to your slicer on this one. You might even take a couple layers off the top, I