Thingiverse
Bowden bracket for FT-5
von Ishampadron
32
Downloads
14
Likes
1
Makes
Clips on above the extruder. Screw in a bowden tube fitting and then attach the tube. On the end closest to the spool you can add another fitting and mount it to the frame. This will keep the filament from snagging on anything.
The short end of the bracket the right side.
To load filament simply slide the mount up and feed the filament. Then slide it down over the extruder when its fed.
The short end of the bracket the right side.
To load filament simply slide the mount up and feed the filament. Then slide it down over the extruder when its fed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
