Thingiverse
Bowden Tube Clamp
von GregNuspel
27
Downloads
13
Likes
0
Makes
This is to solve the problem of the Bowden tube moving while printing. I found clips were not solving the problem so I created this. I hope it helps you if you have had the same problem.
With clip https://youtu.be/Wr5Uji_htBo
With clamp https://youtu.be/6qZytDXAGsg
With clip https://youtu.be/Wr5Uji_htBo
With clamp https://youtu.be/6qZytDXAGsg
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!