Thingiverse
Bowling Ball Holder
von tlmxcpmpp
23
Downloads
14
Likes
0
Makes
This was a quick Design.
Started a New Bowling Leauge and the New side of the Bowling center remolded and removed some ball stands.
So i decided to make a stand that was durable and easy to place on Table or Floor.
Out of both designs the Square one is more stable and harder to knock over. The round one is also hard to knock over but that one still tips when hit hard enough.
Both designs can be made out of ABS or PLA, PLA however allows you to spin the ball to clean it.
The ABS ball is harder to spin.
Started a New Bowling Leauge and the New side of the Bowling center remolded and removed some ball stands.
So i decided to make a stand that was durable and easy to place on Table or Floor.
Out of both designs the Square one is more stable and harder to knock over. The round one is also hard to knock over but that one still tips when hit hard enough.
Both designs can be made out of ABS or PLA, PLA however allows you to spin the ball to clean it.
The ABS ball is harder to spin.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
