Bowling Pin Passthrough

This is a simple, bowling pin passthrough. Print for lots of fun!

I must give credit where credit is due—GemoGens(https://makerworld.com/en/@GemoGens) was the first to create a bowling pin passthrough! Be sure to check out their page and show them some love.

Filaments used for both the body and spiral: White PLA by Bambu and Red PLA by Creality.

**Main settings: **

1) .2mm layer height.
2) No brim(if you feel like you'll need one, just put it on the spiral).
3) No supports
4) 15% Gyroid infill for both objects.
5) 2 perimeters(walls).

The rest of the settings are pretty standard. All you really need is a finely tuned printer. The custom support is a .25mm gap, so make sure your printer can handle that or else the Body may fuse with it. Do not remove it or else the Body *will* fail.

**If you'd like to support my work, feel free to follow this link: https://buymeacoffee.com/devilish3dprints - your support is very much appreciated :)**