Thingiverse
Box & Lid
31
Downloads
17
Likes
0
Makes
L=6cm x W=6cm x H=4cm
Walls and lid 4mm thick.
Note:
Raft and support structures were not required in my case but you may find a raft useful if you have a problem with large flat objects sticking to the platter. Also some supports may be used in cases where hinge holes collapse.
Prints beautifully using ABS filament on Flashforge Dreamer.
Created with Tinkercad 09/01/2017.
Walls and lid 4mm thick.
Note:
Raft and support structures were not required in my case but you may find a raft useful if you have a problem with large flat objects sticking to the platter. Also some supports may be used in cases where hinge holes collapse.
Prints beautifully using ABS filament on Flashforge Dreamer.
Created with Tinkercad 09/01/2017.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
