Thingiverse
Box Cutter Blaster
von BaronWaste
17
Downloads
9
Likes
0
Makes
Uses a Nerf Snapfire spring (or any spring that fits dimensions of around 17.5-18mm by 65mm) and four screws (I used Longshot screws).
Designed as a hold out blaster. No catch or trigger just pull and release.
The ID of the barrel can be adjusted dependent on the darts you are using as I found that some fitted better than others.
There are some finishing touches that I plan to make but mostly for fit and finish.
The files with Jolt on the end have been adjusted so they should allow a jolt spring (17.5mm x 50mm) to be used.
Designed as a hold out blaster. No catch or trigger just pull and release.
The ID of the barrel can be adjusted dependent on the darts you are using as I found that some fitted better than others.
There are some finishing touches that I plan to make but mostly for fit and finish.
The files with Jolt on the end have been adjusted so they should allow a jolt spring (17.5mm x 50mm) to be used.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!