Thingiverse
Box Driver M4
von Syumijin
10
Downloads
8
Likes
0
Makes
I made a box driver for 4 mm nut.
There are holes in the center of the shaft, so the bolts do not interfere.
It was designed assuming a PLA filament.
In the case of ABS filaments it shrinks, so you should print with a size of 105%.
There are holes in the center of the shaft, so the bolts do not interfere.
It was designed assuming a PLA filament.
In the case of ABS filaments it shrinks, so you should print with a size of 105%.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
