Slicer Discord
Box Fan Filter Attachment – 3D-printbaar model van MakerWorld MakerWorld
Other House Models

Box Fan Filter Attachment

454 Downloads
182 Likes
346 Makes
Model downloaden
NEVER CLEAN YOUR BOX FAN AGAIN. Tired of the pesky pet hair and/or dust collecting in the grates of your box fan(s). This model is my solution to the annoying chore of having to clean dust off the fan grates. (Also great to help filter allergens and keep pests out for use in windows) (Not A Substitute For Air Purifiers) Purchase Required Materials: 20"x20"x1" AAF Flanders Nested Fiber Glass Air Filter https://www.walmart.com/ip/16225740 Simply place these clips on the Back Top 2 screws and Back Middle 2 screws of the box fan. (Bottom clips not needed) Slide the filter in the Middle Clips at around a 45 degree angle. Snap the filter into the Top Clips. Replace Filters Every 1-2 months or until filter is visibly dirty. Dirty Filter: Clean Filter:
Categorie
Other House Models
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Eendelig Hardware nodig
Supports 1/3
Montage 0/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Zelfde ontwerper, meer platforms

Pax Prints publiceert ook op

16 extra modellen op 1 andere platforms

Geverifieerd door overeenkomende modeltitels op platforms.
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

1 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie