Thingiverse
Electronics
Go to Model
Box for resistors
55
Downloads
113
Likes
1
Makes
This is a box to store resistors, the box have magnets to keep it closed.
Use a 1mm steel wire for the hinge.
Use 2 round magnets glued in the cover, and 2 screws in the botton, heat the holes in the box and tighten the screws.
Print it preferably in PETG.
I have uploaded the .f3d model too as everyone should do.
Use a 1mm steel wire for the hinge.
Use 2 round magnets glued in the cover, and 2 screws in the botton, heat the holes in the box and tighten the screws.
Print it preferably in PETG.
I have uploaded the .f3d model too as everyone should do.
onolox also publishes on
10 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
