Thingiverse
Box for speed controller ZFC39
by Jimka
5
Downloads
8
Likes
0
Makes
If you notice any problems, write a comment and I will correct the model.
***
Size: 90x70x20
***
All holes are designed for 3mm screws. Those that are used in computers.
***
The wall thickness is 2 mm, which provides the structure with sufficient rigidity.
***
Note: Remember that automatic speed control only works on FAN1, FAN2 and FAN3 are controlled manually by resistors on the board. If you need more automatically controlled fans, you need a splitter and you can connect them all to FAN1.
***
In development I use 12v big connector, but a classic screw connector will also fit there. The hole is 8mm in diameter.
***
.stl - for slicer and print
.sldprt - for editing by the solidworks
***
Size: 90x70x20
***
All holes are designed for 3mm screws. Those that are used in computers.
***
The wall thickness is 2 mm, which provides the structure with sufficient rigidity.
***
Note: Remember that automatic speed control only works on FAN1, FAN2 and FAN3 are controlled manually by resistors on the board. If you need more automatically controlled fans, you need a splitter and you can connect them all to FAN1.
***
In development I use 12v big connector, but a classic screw connector will also fit there. The hole is 8mm in diameter.
***
.stl - for slicer and print
.sldprt - for editing by the solidworks
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!