Thingiverse
Box UNO junior
von Blutruf
0
Downloads
1
Likes
0
Makes
Layer height: 0.12mm
Outer shells: 3
Filling density: 15%
Filling pattern: honeycomb
Print speed: 40mm/s
Travel speed: 70mm/s
Extruder: 210°C
Platform: 50°C
No support needed.
I had to sand the edges of the lid slightly to achieve a good fit, using sandpaper with a grit of 400.
Outer shells: 3
Filling density: 15%
Filling pattern: honeycomb
Print speed: 40mm/s
Travel speed: 70mm/s
Extruder: 210°C
Platform: 50°C
No support needed.
I had to sand the edges of the lid slightly to achieve a good fit, using sandpaper with a grit of 400.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!