Thingiverse
BPI-R4 Vented Case Lid
by RedLetter20
2
Downloads
2
Likes
0
Makes
This is my first take on designing a lid to help keep the BPI-R4 cooler, while still keeping a majority of the original case. First print of the first version, and the lid fits almost perfectly. It's ready to use, but there are notes below for some things that could be improved, I just haven't had time to revisit it yet.
The `.step` files are included as-well, so feel free to modify to suit your needs.
---
NOTES
- The screw holes for the fans need a deeper countersink with a slightly larger diameter. The screw heads don't sit perfectly flush currently, at-least not with standard PC fan screws.
- The fans used are 40mm x 10mm. Anything thicker than 10mm likely wont fit.
- The inlays do not print very well, I definitely made them too thin.
- The lid fits flat with the case, but some added support in the middle will prevent flexing if you push on it.
The `.step` files are included as-well, so feel free to modify to suit your needs.
---
NOTES
- The screw holes for the fans need a deeper countersink with a slightly larger diameter. The screw heads don't sit perfectly flush currently, at-least not with standard PC fan screws.
- The fans used are 40mm x 10mm. Anything thicker than 10mm likely wont fit.
- The inlays do not print very well, I definitely made them too thin.
- The lid fits flat with the case, but some added support in the middle will prevent flexing if you push on it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!