BQM-74E Chukar

small target drone for the US Navy
Used in the Iraq war as decoys and to flush out radar

this model is too small for microarmor ( it'd have a wingspan of only 7mm ), but it should be printable by resin printers after accounting for the overlapping solids used ( fuselage, engine, stabs, wing and minor detail part )

I did test that it would slice for a FDM printer at 1/160 ( N-guage ) scale, so 1/144 should be good. It is lo-poly, so don't expect any real detail or panel lines.
No test print available

model in full dimensions in blender 2.82 and exported from blender 2.79b*
the .stl is 1/100

I've had issues exporting .stl's from 2.82 for Cura; 2.79b and 2.80 export the same mesh to different file sizes, too. So I export the mesh from 2.79b for consistency's sake.