Brace for AMS Lite

I felt that the feeder units was a little loose even with the screws tight and I didn't want to damage them and at the same time I also needed a guide for my ptfe-tubes so they go the way I want them on my setup, so I designed a combination of a brace for the feeder units and a guide for the ptfe-tubes. You just put it on and use one M3 screw on each side to make it tight, I used 12mm long ones but you can fit up to about 15-16mm long ones. For the A1 Mini you need to print the brace with the ptfe guide in 2 parts and glue them together after, if you just want the brace or if you have a bigger printer you can print it as one part. This is my first design that I share so if there's any problem or anything, just leave a comment and I do my best to fix it.