MakerWorld
Sport & Outdoors
Model downloaden
Brace Hinge V2
443
Downloads
205
Likes
219
Makes
This is a re design of my original this one utilizes M3 nuts instead of brass inserts. It is also optimized for strength. BOM 2 M3x12MM SHCS (These will replace the two original M3x8 SHCS that connect the hinge to the Pica-tinny Mount) 2 M3 Hex Nuts (Im using Nylock nuts, but either should work.) 1 M4X30 SHCS 1 M4 Hex Nut (Im using Nylock nut, but either should work) 1 8MM OD X 20MM Long Light load 3D Printer Die Spring Everything is basically the same as the original except this one is stronger, uses hex nuts, and needs little bit longer screws.
WrenchWorks3D publiceert ook op
55 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
