Thingiverse
Bracelet Rack
von smorgana
32
Downloads
21
Likes
0
Makes
Print one rack, 4 rods, and 8 end caps.
I used epoxy glue to glue the parts together.
you may need to sand the ends of the rods to fit them into the end caps.
All parts print on an Ultimaker 2+ without supports.
I used epoxy glue to glue the parts together.
you may need to sand the ends of the rods to fit them into the end caps.
All parts print on an Ultimaker 2+ without supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
