Thingiverse
Bracket for Miroir MP60 projector
von titrisol
0
Downloads
0
Likes
0
Makes
Bracket to use Miroir MP60 for drafting
I had this old mini projector, and planned to use it for tracing images on paper. However, the image was always upside-down.
Since the projector doesn't have any adjustments, a quick and dirty solution was to make a bracket to mount it 180degrees in the tripod/holder.
You need a 1/4-20 screw to mount the projector and a 1/4-20 nut to mount the bracket in the stand.
Printed in PLA+ at 0.3mm layer height worked just fine.
I had this old mini projector, and planned to use it for tracing images on paper. However, the image was always upside-down.
Since the projector doesn't have any adjustments, a quick and dirty solution was to make a bracket to mount it 180degrees in the tripod/holder.
You need a 1/4-20 screw to mount the projector and a 1/4-20 nut to mount the bracket in the stand.
Printed in PLA+ at 0.3mm layer height worked just fine.
titrisol veröffentlicht auch auf
11 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
