Thingiverse
Bracket
by MattMo3D
0
Downloads
0
Likes
0
Makes
A simple strong spool holder with filament demo tokens and slot.
Print settings : Print flat / no supports needed / 15% infill / 0.2 layerheight.
Tokens can be printed with 45cm filament cut offs if using direct drive.
Only 18 grams of filament needed for one bracket.
Screw holes are 3mm.
Enjoy
Happy Printing!
MattMo
Print settings : Print flat / no supports needed / 15% infill / 0.2 layerheight.
Tokens can be printed with 45cm filament cut offs if using direct drive.
Only 18 grams of filament needed for one bracket.
Screw holes are 3mm.
Enjoy
Happy Printing!
MattMo
MattMo3D also publishes on
16 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
