Brad nail container

I created this because I was frustrated with my brad nails falling off my pegboard. The factory packaging it thin and flimsy. It also varies depending on what brand you get and leads to a mess or lost nails. I used 8x3 and 8x2 mm round magnets to hold the lid closed and hold it in the open position as well. Pause at the beginning of layer at 2.8 mm to install 8x2 magnet in the lid (pause is added if you use my profile). I superglued the 8x3 magnet in the base after printing was complete. Please be sure to put the magnets in the lid with the polarity in the same direction. (if not the will push away from each other vs pull toward each other). double check the polarity of the base magnets before gluing them in.