Thingiverse
Brake Caliper Alignment Block
door amsgator
1
Downloads
3
Likes
0
Makes
Are you having trouble getting rid of that dreaded brake rub? This caliper alignment block is just what you need to perfectly center your caliper on the rotor. This should fit any hydraulic brake caliper that utilizes the Shimano B05S-RX, Tektro E10.11, or similar sized two-piston brake pads from other manufacturers.
I've included alignment blocks for the most common rotor thicknesses, and some extras for rotors that are partially worn down. If you need a different size, comment with the size you need, and I'll do my best to get it uploaded.
Be sure to print with extra walls and infill (I used PETG with 5 walls and 60% infill) to ensure it's strong enough to be squeezed between the pistons without breaking.
No supports needed if printed standing up.
How to Use:
* Uninstall the wheel and measure your rotor's thickness.
* Remove the brake pads and retaining spring from the caliper and push the pistons back into the caliper using a piston press. Be careful not to damage the pistons.
I've included alignment blocks for the most common rotor thicknesses, and some extras for rotors that are partially worn down. If you need a different size, comment with the size you need, and I'll do my best to get it uploaded.
Be sure to print with extra walls and infill (I used PETG with 5 walls and 60% infill) to ensure it's strong enough to be squeezed between the pistons without breaking.
No supports needed if printed standing up.
How to Use:
* Uninstall the wheel and measure your rotor's thickness.
* Remove the brake pads and retaining spring from the caliper and push the pistons back into the caliper using a piston press. Be careful not to damage the pistons.
amsgator publiceert ook op
13 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
