Thingiverse
Brass - Organizer
von GarbanzoBill
5
Downloads
4
Likes
0
Makes
This insert was made for the "FRED 2nd edition, 2nd printing" of Brass. I'm not sure if it will work for the "FRED 2nd edition, 1st printing" or the "Warfrog 1st edition" (judging from pictures on BGG, I suspect that it may work for those versions, too).
The inner dimensions of the card tray measure 60 x 92.5 mm^2, which fit the sleeves I use (Gamegenic Matte Standard American-"Green").
As hinted by the filenames, print:
BrassCards-x3.stl three times,
BrassPlayer-x4.stl four times, and
everything else once.
The inner dimensions of the card tray measure 60 x 92.5 mm^2, which fit the sleeves I use (Gamegenic Matte Standard American-"Green").
As hinted by the filenames, print:
BrassCards-x3.stl three times,
BrassPlayer-x4.stl four times, and
everything else once.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!