Brass Prep Station

Brass Prep Station, took what hcpookie did and remixed it/redesigned it.

For the gear box plates, recommend a 20% infill and 3-4 perimeters or walls.

For the gears (main helical gear and small helical gears), 4 perimeters and 70% infill plus 5 top and bottom layers.

For the housing 2-3 perimeters and 20% infill is a-ok.

For the tool posts, 4 perimeters.

For the gear shafts, 4 perimeters.

**note: The pics are not 100% complete, I was waiting on the motor and a few pieces of hardware**

There are two gearboxes you can print:

a 400RPM gearbox
and a 250RPM gearbox

I highly recommend the 250RPM gearbox as it is quite a bit higher in torque.

Anything marked with a X6 you will need to print 6 of.

This is the parts list needed:

https://www.amazon.ca/gp/product/B071GTTSV3/ - 12v 200 RPM Greartisan style motor with 31mm bolt circumference.

https://www.amazon.ca/gp/product/B09HV9HZQ6 - The bearings are 22OD X 8MM ID X 7MM thick skate board bearings, you need