Brass Shell Decapper Case Holder

This replaces the specific caliber shell holder in your press when depriming your brass. I use a universal decapping die and like to deprime all the mixed brass of different calibers i pick up at the range. This allows you to just deprime everything from 9mm to 300wm without having to change out the shell holder (with a universal decapping die!)

To use this, install it like any other shell holder. install the pin in your decapping die as far in as it will go. then you can just hold the case head with your fingers, slip it up into the die until you feel the pin go in the flash hole, and raise your ram and punch the primer right out. it will drop right out down through the shell holder like normal. just watch your fingers so you don't pinch them. That's why you adjust the pin down as far as possible so you have room to hold the case. Also make sure you have the pin in the hole before you press so you don't bend or break the pin.