Thingiverse
Bread Lame
von kitlaan
382
Downloads
334
Likes
1
Makes
Rectangular bread lame, using standard double edge razor blade and no extra hardware parts.
This design allows the blade to be safely stored, and allows two different exposed blade lengths.
The holder is roughly 45mm x 30mm x 7mm, and is easily holdable.
Ideally printed using 0.1mm layer thickness to allow for better grippage of the blade. Depending on your printer, you may need to clean up some edges; **you want a loose fit** to the two halves.
History:
2020-09-24 (v5):
* First uploaded version
2020-09-29 (v6):
* Added finger groove
* Increased Top/Bottom tolerance for easier separation
* Minor tweaks in clip size
2020-10-15 (v6 NC):
* Added a "no clip" version of v6 by request
This design allows the blade to be safely stored, and allows two different exposed blade lengths.
The holder is roughly 45mm x 30mm x 7mm, and is easily holdable.
Ideally printed using 0.1mm layer thickness to allow for better grippage of the blade. Depending on your printer, you may need to clean up some edges; **you want a loose fit** to the two halves.
History:
2020-09-24 (v5):
* First uploaded version
2020-09-29 (v6):
* Added finger groove
* Increased Top/Bottom tolerance for easier separation
* Minor tweaks in clip size
2020-10-15 (v6 NC):
* Added a "no clip" version of v6 by request
kitlaan veröffentlicht auch auf
50 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!