Thingiverse
Breadboard Legs
by solarmatter
1
Downloads
0
Likes
0
Makes
These legs are for holding up a breadboard while prototyping a circuit.
I was getting fed up with the legs of my ESP-32 dev board dangling over the edge of the breadboard and bending the pins on the other side. This is something I knocked up and depending on how it works there may be a future revision.
My breadboard is 52mm wide.
I was getting fed up with the legs of my ESP-32 dev board dangling over the edge of the breadboard and bending the pins on the other side. This is something I knocked up and depending on how it works there may be a future revision.
My breadboard is 52mm wide.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!