Brick Flowers Spike

Printed a multitude of "brick flowers" and wanted a way to secure them in the dirt outside.

The model is a single brick button insert with a spike similar to a pathway light. I like the square single tile as a base for my flowers, and have only tested it using this as a method of attachment. For me, full size and 50% original size for the original flower design worked without issue.

- 4mm nozzle
- 3 Perimeters
- 15% infill, grid pattern
- 30mm/sec Initial layer, 60mm/sec after
- Standard Supports
- Sliced in Cura

Support takes a little force to remove on the full size, but mine came off in one peace.