Brick Titanosaurus

Brick Titanosaurus 1:1 scale. Inspired by Jurassic World. Use care when removing supports! When assembling, if you use too much force, you will break the pins, clips, and/or joints! If your print tolerances are too tight, try increasing/decreasing the body piece. OR if you already have it printed, try using gentle heat, such as a heatgun (from a few inches away) to warm the plastic, then assemble. Using too much heat will melt your plastic. Remember, this is FDM printing, not injection molding like major brick brands. Pins, joints, hinges, etc. are more fragile than popular brick brands injection molded bricks! On this model, the neck joints are especially sensitive—don't use too much force. Using too much force will break smaller pieces! If you have trouble assembling, use a lighter for 1 or 2 seconds and snap the piece in place. Again, using too much heat/flame will melt plastic. Check out the Brachiosaurus!