Bridge Flow and Speed calibration test

Do you have bridging issued with drooping lines or lines that are not connecting to their adjacent ones? Inspired by some of the experiments that other creates like @Make Wonderful Things have done with their Unsupported Bridge Experiments - Free 3D Print Model - MakerWorld, and some of the information compiled in the Bambu Lab Wiki at How to Improve Bridge Quality in Bambu Studio | Bambu Lab Wiki, I wanted to make a simple test that tests the pure bridges, without adjacent starting edge or additional layers on top that obfuscate the side to side adhesion. This model has a series of plates with a model that prints: Two small rectangular pillars about 6x12.5mm (~¼ x ½ in). Over a 40mm gap as a reasonably long bridge. Each bridge is a single top layer of 0.20mm. The long edge is not supported by any adjacent walls, thus the first line of the bridge needs to print “in thin air” to test line bonding without the initial line having an adjacent edge to adhere to as a guide. Each model is rep