Thingiverse
Bridging and wall test
von Shellduck
102
Downloads
36
Likes
1
Makes
The bridge test was made to test the bridging capabilities and the difference compared to using support.
The bridges hags 5mm over the plate, is 3mm thick and 4mm wide.They span over a distance from 20mm to 90 mm with steps of 10mm
The wall test was made to test the precision of walls printed in two directions at a time. The thickness of the wall span from 0.25mm to 2mm with steps of 0.25mm.
The bridges hags 5mm over the plate, is 3mm thick and 4mm wide.They span over a distance from 20mm to 90 mm with steps of 10mm
The wall test was made to test the precision of walls printed in two directions at a time. The thickness of the wall span from 0.25mm to 2mm with steps of 0.25mm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
