Thingiverse
Bridging mini-test (also tests cooling, stringing, adhesion)
von Zzzy
8
Downloads
4
Likes
0
Makes
- Test your bridging/cooling settings!
- Check if your bed adhesion is good enough for small footprint parts.
- Prints in minutes and uses less than 1 gram of filament.
- Check if your bed adhesion is good enough for small footprint parts.
- Prints in minutes and uses less than 1 gram of filament.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
