broken heart Hueforge

This print was done at a 0.04mm layer height on a P1S with the door and top glass open without any problems. It was also printed on an H2S, where I similarly needed to open the door and top glass and lower the temperature by 5°C; the result was incredible. Project: broken-heart.hfp Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm The Model is 389.42x389.42mm in size You may print at higher layer heights below the Base Thickness of 0.48mm The Max allowed Thickness is 2.72mm and the Actual Thickness is 1.8mm #000000 PLA BambuLab Matte Charcoal Transmission Distance: 0.6 #c00d1e PLA BambuLab Basic Red Transmission Distance: 4 #8bd5ee PLA BambuLab Matte Ice Blue Transmission Distance: 3.5 #e7ceb5 PLA BambuLab Basic Beige Transmission Distance: 8 #ffffff PLA BambuLab Basic Jade White Transmission Distance: 5 This print uses 5 unique filaments Swap Instructions: Start with BambuLab Matte Charcoal At layer #15 (0.8mm) swap to BambuLab Basic Red At layer #21 (1.04